m menu image  m home m cart

Pull Arm for Polar Paper Cutter 92 EMC, 92 EMC MON, 92 ED 027315


Add to Cart:

  • Our Part Number: PA800

This complete pull arm assembly (sometimes called a knife draw arm) fits Polar 92 EMC (after machine serial number 5311001), Polar 92 EMC MON (after machine serial number 5311001), Polar 92 E, Polar 92 ED, and Polar 92 S guillotine paper cutters. (equivalent to Polar 033245, 033245a, 027315, and 027315a)

After approximately 1983 the Polar 92 pull arm style changed to this type that uses a single center shear bolt.  This new style pull arm assembly can still be used in the older (pre 1983) Polar 92 cutters.  However it means that when a shear bolt breaks, the newer style single center shear bolt will have to be used for a replacement, not the older style twin shear bolts.

These are all completely new, non-OEM, aftermarket parts.  The arms themselves are machined complete from SAE 1045 steel.  This assembly is supplied as shown in the photo, complete with the following parts:

Upper Threaded Arm (232382, 232382a, complete with needle bearing 205118a, and dowel pin 200855a)

Upper Jam Nut - Left Hand (233185, 233185a)

Turnbuckle Nut (258644 ,258644a, or 258644a)

Lower Jam Nut - Right Hand (233186, 233186a)

Lower Threaded Arm (233116, 233116a, complete with guide rod bushing 233136, 233136a and pins 201624a)

Lower Connector (017776, 017776a, complete with guide shaft bushing)

Guide Shaft (232380, 232380a, with guide shaft set screw 202293a)

Shear Bolt (017771, 017771a, complete with shear bolt nut 232343, 232343a)